A lab report of forces being in equilibrium.

Purpose. The purpose of this lab was to understand equilibrium. To do this, you must start the equilibrant of the resultant of three vectors, both mathematically and diagrammatically and gift the results. Procedure: A) Put the weights necessary for to each one(prenominal) of the vector forces on each rook. B) Set the wheels of the force dodge at the proper angles, including the work equilibrant. C) When placing the hooks on the wheels, be careful to hold the give in in place so it does non flip over. D) To test, loosen the shaft in the middle of the board. If nonhing moves, the system is in equilibrium. E) tune the mathematically calculated vectors the same way the graphical ones were tested repeating step A-D Error Analysis: Errors deal realise in this lab in both collecting information and in testing. While graphically collecting entropy, it is easy to not be precise accustomed the ruler and protractor given. To fix this, a ruler and protrac tor with good precision are needed. Also, it is serious to implement a large exceed in devote to lessen error because most rulers but restrain millimeters. When calculating the equilibrant mathematically, it is important to check all transaction and use a ready reckoner because if one error is made, a lot of important data could be incorrect.

While testing, it is possible to have the incorrect touchstone of weight on the hooks. It is important to know that each hook contributes to the mass so that the student will not spue on more weight than necessary. Another error that can occur while testing is t hrowing the system off because the table was! not held in place while all the weights were world hooked To fix this, you should collect for help while place weights on. Finally, it is important to make... If you want to get a full essay, order it on our website: OrderCustomPaper.com

If you want to get a full essay, visit our page: write my paper